Universal Audio UAD Manuel télécharger pdf (Page 23)

Apollo Twin Hardware Manual Chapter 3: Controls & Connectors 23

Rear Panel

Refer to the illustration below for control descriptions in this section.

Note: All rear panel ¼” jacks can accept unbalanced TS (tip-sleeve) or balanced

TRS (tip-ring-sleeve) connections.

Apollo Twin’s rear panel elements

(14) Mic/Line Inputs 1 & 2

The jacks for channels 1 & 2 accept either a male XLR plug for connecting to the mic

input, or a ¼” phone plug for connecting to the line input.

The input that is used for the channel (mic or line) is speciﬁed with the Input Type but-

ton (11a).

(15) Monitor Outputs

Connect the powered monitor speakers (or speaker ampliﬁers) here. Volume is set with

the Level knob (1) when Monitor is selected (6) with the Monitor button (10).

(16) Line Outputs 3 & 4

These ¼” phone outputs are accessed via software (Console or DAW). Line outputs 3 & 4

are used to send audio to other equipment.

(17) Power Supply Input

The included power supply must be connected here (Apollo Twin cannot be bus pow-

ered). Rotate locking connector to prevent accidental disconnection.

Important: After ensuring the locking barrel tabs are aligned with the chassis slots

and the barrel is fully inserted, rotate the barrel to secure the connector to the

chassis.

(18) Power Switch

This rocker switch applies power to Apollo Twin. Switch to OFF when not in use.

Caution: Before powering Apollo Twin, lower the volume of the monitor speakers

and remove headphones from your ears.

MIC/LINE 1

MIC/LINE 2

3 L

4 R

LINE OUT MONITOR

OPTICAL IN

OFF ON

12VDC

POWER

151617

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 32 33

Pas de commentaire

Universal Audio UAD Manuel Page 23