Universal-audio Thunderbolt Option Card Manuel d'utilisateur télécharger pdf

Please read the other side of this guide for important operational information.

Hardware Installation Procedure

Secure the option card into place

a) Secure the card into the expansion bay with the two screws

saved from step 2b.* Turn the screws clockwise with the hex

wrench until they are snug, but do not over-tighten.

b) Hardware installation is complete. See instructions on reverse

side before making Thunderbolt connections.

Prepare for installation

a) Power off Apollo and disconnect all cables from the unit.

b) Place Apollo on a stable, ﬂat, static-free surface with the rear

panel facing you.

c) Gather the option card, supplied hex key wrench, and these

instructions so they are within easy reach.

Remove Apollo’s expansion bay cover plate

a) Locate the rectangular metal plate that covers Apollo’s

expansion bay. It’s on the left side of the rear panel, next to the

Power In connector.

b) Using the supplied hex key wrench, remove the two hex screws

from the cover plate by turning them counter-clockwise.

Save these screws! They are used to secure the card into place.

Slide the option card into Apollo via the guide rails

a) After discharging static electricity by touching unpainted metal

on Apollo’s rear panel, remove the card from its anti-static

bag. Handle the card by its edges and avoid touching the gold

connector contacts.

b) Carefully align both edges of the card within the two plastic

guide rail slots located inside both sides of the expansion bay.

c) Slide the card all the way into Apollo. There will be a slight

“snap” as the card is completely inserted. The card’s faceplate

should align perfectly with Apollo’s rear panel.

THUNDERBOLT

™

OPTION CARD

–

INSTALLATION & SETUP GUIDE

Read Before Proceeding With Installation

Your Apollo may require an important update before it can communicate via Thunderbolt. Detailed information is on the reverse side of this guide.

www.uaudio.com/support/thunderbolt

Items are gathered and ready for installation.

Remove both cover plate screws with the hex wrench.

Slide card into both plastic guide rail slots.

Secure card with the two saved hex screws.

Note: Before handling the option card, discharge any static

electricity by touching unpainted metal on Apollo’s rear panel.

Note: Follow all instructions in this guide carefully. Failure to do so could damage the equipment and void the warranty.

*4-40 x 1/4” button head cap screws, 1/16” hex wrench

1 2

Résumé du contenu

Page 1 - OPTION CARD

Please read the other side of this guide for important operational information.Hardware Installation Procedure4 Secure the option card into placea) Se

Page 2 - Using Apollo with Thunderbolt

Technical SupportConnecting Apollo to the computer• Connect Apollo to the computer with a standard Thunderbolt cable (not included) in either option

Commentaires sur ces manuels

Pas de commentaire

Universal-audio Thunderbolt Option Card Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Audio Universal-audio Thunderbolt Option Card. Universal Audio Thunderbolt Option Card User Manual [en] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Universal-audio Thunderbolt Option Card